Home / Products / Engineered Specialty Mortars / ALC Panel Bonding Mortar

ALC Panel Bonding Mortar JC/T 907-2018

A thin-bed bonding mortar for autoclaved aerated concrete panels — strong bond, good water retention, thin-layer application.

ALC Panel Bonding Mortar packaging

ALC Panel Bonding Mortar

Standard: JC/T 907-2018

A thin-bed mortar dedicated to bonding autoclaved aerated concrete (ALC) panels and blocks. It features high bond strength, good water retention, thin-layer application, anti-slip and low hollowing, markedly improving panel installation quality and efficiency — widely used in prefabricated buildings and AAC wall construction.

High bond strengthGood water retentionThin-layer applicationAnti-slipNo hollowing
KEY FEATURES

Product Features

01

High bond strength

Bonds firmly with ALC panels and blocks for reliable, secure installation.

02

Good water retention

Prevents over-fast water loss into the substrate that would weaken the bond.

03

Thin-layer

A thin mortar bed is enough, saving material and raising productivity.

04

Anti-slip

Good initial tack and anti-slip keep panels stable and in place after erection.

05

No hollowing

Full, dense bonding reduces common defects like hollowing and cracking.

06

High efficiency

Simple to apply with moderate setting time for continuous, fast work.

Technical Parameters

FormSingle-component dry powder (add water and mix)
StandardJC/T 907-2018
ApplicationALC panel / block bonding, AAC block masonry
PackingBagged, subject to factory packaging
QCEvery batch tested; test reports and certificates shipped with goods

Applications

  • Bonding of ALC autoclaved aerated concrete panels
  • Masonry and jointing of AAC blocks
  • Installation of lightweight partition panels
  • Bonding of wall connections in prefabricated buildings
APPLICATION

Construction Steps

General application steps; refer to the technical brief for specifics

1

Surface prep

Clean dust and oil from panels and substrate; check flatness and verticality.

2

Layout

Snap layout lines to locate panel positions as designed.

3

Apply mortar

Full-bed or ribbon-apply mortar along the bonding face, full and even.

4

Erect & press

Set the panel and press firmly, correcting verticality and flatness promptly.

5

Joint & cure

Strike joints, remove excess mortar and cure in good time.

MA
CNAS
Batch-Tested · Traceable Quality

All products are produced to national / industry standards and tested by third-party laboratories. Reports carry MA / CNAS marks and the official inspection seal, and accompany every shipped batch with the certificate of conformity.

RELATED

Related Products

Click a product to view its detail page